Spacer tubes

Spacer tubes are manufactured from steel, stainless steel or brass. They are used predominantly in the electrical industry. As for all Seeberger products you will be able to purchase the spacer tubes in all dimensions and with all special tolerances. The principal dimensions, however, you will be able to learn from the table below:

Diameter Spacer tubes

Outside
0.197 in (5 mm)
0.197 in (5 mm)
0.236 in (6 mm)
0.236 in (6 mm)
0.315 in (8 mm)
0.394 in (10 mm)

Inside
0.098 in (2.5 mm)
0.118 in (3 mm)
0.138 in (3.5 mm)
0.157 in (4 mm)
0.197 in (5 mm)
0.236 in (6 mm) (See SN 60310 as well)

To SN 60310 the linear tolerance for spacer tubes of up to 1.969 Inch length is -0.008. Up to 2.953 Inch it is -0.012. These tolerances we have set as a standard. Spacer tubes of greater lengths will be manufactured with special tolerances, when so requested. Over and above the dimensions the SN 60310 provides for we are able to manufacture many more variants within short periods of delivery.

Length

For Seeberger there are no special lengths. All lengths from 0.079-19.685 Inch (2-500 mm) are standard. The linear tolerance of the standard-spacer tubes corresponds to the DIN-mean – this keeps costs down more than tight tolerances do. Naturally the tolerances of the spacer tubes may be cut to size to comply with the requirements.

Outer diameter

The outer diameter may be specified, upon request even with minimum and maximum tolerances. However, standard tolerances are the most cost-effective solution.

Inner diameter

The inner diameter may be specified with minimum and maximum tolerances.

Wall thickness

We are able to realise almost any wall thickness.

Surfaces

We are able to supply almost any surface.

 

Seven reasons speaking in favour of Seeberger:

Seeberger spacer tubes – Quality “Made in Germany”

Top quality at cost-effective prices.

A diversity of materials that makes you enthusiastic

Profit from our capability in the use of diverse materials to find the optimal solution for any one of your products.

Standard dimensions – the cost-effective alternative

Spacer tubes are specified as a special part in many designs. Frequently there is no need for this, as Seeberger has a large range of standard raw materials on stock. This is why you should talk to us during the design phase already. We propose that you cut down on your cost by using our standard tubes. We have the right product for almost any application.

No minimum quantities

We at Seeberger do without minimum quantities. It will be no problem for you to call off very small quantities for samples, pilot productions and/or spare parts.

Short periods of delivery

Particularly the use of standard dimensions allows us to realise very short periods of delivery. Should there be any need to speed up the delivery period even more our express service will be pleased to serve you.

Special solutions tailored to your needs

You have unable to find the fitting product in our product range? Then we will design this product for you. Seeberger supplies tube products with special dimensions, tolerances, materials and surfaces. In exact compliance with the specification fitting perfectly for your application.

Quick information, extensive know-how

Seeberger does not want the customer to wait. That is why we provide the Product Configurator for a quick run-down. You will find our full product range in our product catalogue. Kindly request the same here. However, a personal meeting will be the best idea to clear all questions – Here you will find the right person to contact.